Installation & Assembly

1: Locate the different components and get the right tools.
2:Attach the Floor Braces to the Legs:
There are 2 types of legs and it is important that you choose the right ones. Make sure to have one “A” marked leg and one “B”
marked leg on each side of the house (2.2). Have the long side of the legs facing the front and back of the house (2.1). The long
side board creating the L shape leg is 3.5” wide and the short side board is 2.5” wide. It is important to attach the right Floor
Braces to the right section of the legs. The Short Floor Braces (the ones with a pre-drilled hole in the middle) attach to the short
side of the legs and the Long Floor Braces attach to the long side of the legs (2.2). Secure the four legs to the Floor Braces using
the 2.5” bolts, washers and nuts. Make sure that there is a washer on both sides of the wood and that the nuts are facing the
inside the house (2.3). Do not fully tighten the bolts.
Tools (Not-
included)
Philips Screwdriver
3: Attach the Floor Center Brace to the Floor
Brace Assembly using the 1.5” Screws (the
shortest screws) and locate per the pre-drilled
holes (3.1). Make sure that the Floor Center Brace
cleat is under the Short Floor Brace making the
Floor Center Brace flush with the Short Floor Brace.
Support and keep in position the Floor Center Brace
while securing it (3.1). Repeat for the other side.
Back Panel (x1)
Left Leg (x2)
Door Panel (x1)
Roof Brace (x1)
Long Floor Brace (x2)
Side Board (6)
Tools Not Included
Wrench 7/16”
Powered tool (Not a must)
2 ½” bolt (x8)
Washer (x16)
Nut (x8)
2 ½” Screw (x4)
1 ½” Screw (x6)
Roof Panel (x1)
Top Side Board (2)
Right Leg (x2)
Floor Center Brace (x1)
Short Floor Brace (x2)
Roof Gables (x2)
Floor Panel (x2
A
A
B
B
Long Floor Brace
Short Floor Brace
Long Side
Short Side
2..1
2.2
2.3
4: Attach the Roof Gables to the Back and
Door Panels. Secure the Roof Gables to the
back side of the Door and Back Panels using the
1.5” Screws (the shortest screws) and pre-
drilled holes. The back of the panels is the side
where the cleat to attach the boards are facing
up 4.2. It is important that the bottom edge of
the Roof Gable is perfectly flush and align with
the top board of the Back Panel and make sure
that it sits all the way down the groove of the
top board. (4.1). To prevent wood cracking do
not over tighten the screws
3.1
Panel Cleat
3.1
4.2
4.1
3.2
Help is available.
The Ultimate Dog House: INSTRUCTIONS