Installation & Assembly

× 2
× 3
4
To assemble the second level
CAGE FRONT & BACK
,
you will need these pieces:
5
To assemble the second level
FLOOR & SIDES
, you will need
these pieces:
7
Finish the assembly with the
ROOF, HAMMOCK & TRAY
.
You will need these pieces:
6
To install the PLATFORMS &
RAMPS, you will need these
pieces:
× 4 (long)
Slide the upper level front and back panels into
place and secure with one long screw in each corner.
Note: each corner screw will secure the intersection
of three panels.
× 2 (short)
× 8 (long)
Slide the mid-level floor (with the
removable hatch door) down into place.
Secure the floor in place with a short
screw in the center of each side.
Slide the upper level side panels into
place and secure with a long screw in
all top and bottom corners.
× 2 (short)
Set the roof panel (with the sliding door)
into place and secure it into place with
a short screw in the center of each side.
Add the hammock into either level.
Rotate the windbell lock out of the way
and slide the debris tray into place.
Your cage is assembled and ready for use!
6.1 Remove the hatch door cover.
6.3 Clip a platform/ramp
set onto the cage in the
lower level.
6.4 Clip the leftover ramp
onto the floor at the
hatch opening and rest
the lower end onto the
platform.
6.2 Snap the ramps onto the underside of the
platforms (as illustrated) to make two
platform/ramp sets.
Made in China