Assembly Instructions

KEY:
L = Left pieces
B = Back pieces
R = Right pieces
F = Front pieces
C = Center pieces
T = Tray
cage assembly instructions
cage: 31"L × 20⅝"W × 54⅜"H
interior: 30¾"L × 20"W × 20½"H (each level)
wire gauge: 9 & 11
wire spacing: ⅞"
getting started!
READ THESE NOTES FIRST:
• Enlist A Friend: This is a large cage and assembly will be
made easier with two people.
parts
4
Before the top panel is attached, it’s a good time to
install the platforms and ramps. Start with removing
the separator door on (C3) (see detail [c]).
Add the platforms and ramps (see detail [d]):
→ Platforms have ‘U’ hooks at front, ‘L’ hooks at back, and
four holes along the cage-interior edge.
→ Ramps have ‘U’ hooks at top, ‘L’ hooks at bottom, and
ridges on the surface.
RAMPS: Front edge ‘U’ hooks link into holes along
edge of platform. Back edge ‘L’ hooks poke down
through cage floor wires. Ramp from lower-level
platform to second floor works similarly —’U’ hooks
link into (C3) floor and ‘L’ hooks poke down through
holes on platform.
Add the hammock (see detail [e]).
→ Hook the quick-links onto the long side-to-side wires.
5 Set the top (C4) panel into place.
Secure the top panel with a short hex screw
in the center on each side.
Rotate the windbell lock out of the way and
slide the removable plastic tray (T) into place.
✩
Your cage is now fully assembled!
LEFT SIDE
FRONT
CENTER
BACK
RIGHT SIDE
TRAY
R3
R2
R1
L3
L2
L1
F3
F2
F1
B3
B2
B1
T
C1
C2
C3
C4
{4} short hex head
screws
{24} hex head screws
{ 4 } rolling casters
{ 1 } allen wrench
{ 2 } metal platforms
{ 1 } hammock
{ 3 } metal ramps
C4
T
(c)
(d)
(e)
Made in China
Ferret Cage
Review these instructions thoroughly before attempting to assemble
cage. If you still require assistance, please contact Customer
Service.
PLATFORM: Front edge ‘U’ hooks should be positioned
on second vertical wire from bottom. Back edge ‘L’
hooks rest on corresponding vertical wire at the back
of the cage.
• Tools: An allen wrench is included. You may want to have
a pair of needle nose pliers available. You may use your own hand
tools but we
DO NOT recommend power drills! Parts can be
over-tightened and damaged/stripped. We are not
responsiblefor this type of damage.
• Count Hardware: Usually, extra screws are included. If the
screw count is short, please contact Customer Service.
• Review All Parts: If parts are bent during shipping,
pieces may be straightened with needle nose pliers. For seriously
damaged pieces, please contact Customer Service.