Rustic Lodge for Pet Congratulations on your purchase! Before you Start check for damaged or missing parts.
Parts List Panels Part?1Part?31 Hardware: ®><2 ><8 ©><1 Floor Support Bar Thumb Screw and Nuts Roof Support Bar Long Thumb Screw (may come in one or two colors, vary by model)
Notes STOP! po you know you can paint or stain your product? Whether you want to add your personal touch, or coordinate your pet's home to your home, do it now before you assemble the house. Simply follow the useful tips at the end of this instruction booklet. Be creative and have fun! When installing wall panels, make sure the two connecting panels are at a 90 degree angle vertical to the ground, and 90 degree perpendicular to each other. Tilting in any way might cause damage to the groove. Part Label.
IMPORTANT ASSEMBLY TIPS Before launching the new line, we conducted hundreds of tests and surveys with pet lovers like you. Thanks to all the feedback, we now have these valuable tips to pass on to you... 2 Assemble on a hard, flat surface. Once assembled, you can easily move the dog house to your desired location. 2 Sort the parts in sequence. We know you are eager to dive in, but spending a moment to lay out the parts by ascending numbers will save you time and frustration later on.
This side of column @ has no assembly hole on top. Note the position of this floor Step 2. Note: After install Panel @, make sure the FLAT side of panel @ and @ are facing inside, and the washed sides are facing out.
Step 3. Step 4. Move assembled @ near to each other. Lift@ upward as shown, then tilt so@ is perpendicular to(5) insertions.
Step 5. Step 6. The assembly should look like this at this point. Take a step back and exam the house against the picture shown below. Note the angels on the corner posts should be pointing upward toward the middle of the house.
Step 7. Front door opening Assembly holes Floor support bin Assembly holes So far you have setup the wall base panels, 2,3, and the 4 column posts. Step back and stand facing the front door open. Do a quick check: ® The FLAT SIDES of the all wall panels are facing inside. ® The floor support beams are located on the lower edge of the flat side of the wall panels.
Step 10. Step 11. Hold panel @ at the two corner cutouts. Slightly angel @ into . Release panel @, then gently push it down.
Step 16. Place door frame 2 into one of the lower corners of the door opening, then push the other end down gently. The side of the frame piece with part # bar code should be facing inside the barn. Same for all door frame pieces. Step 17.
Step 20. Step 21. Parts @ and should be installed with the flange attaching to the inside of the wall panels. Note: If available, use screws with matching color as the corner posts.
Cleaning Instruction It is very important to keep the dog house clean for the benefit of your beloved pet. The easy to assembly design of all homes will be appreciated when it is time to clean your pet's home. Remove one side of the roof panels by reversing the last 3 steps of the assembly instruction. You now have access to the entire inside of the house. We recommend using a detergent with strong grease cutting capabilities and safe to use around you, your kids and your pet.
