Specifications

DV - 520
27
• Mark all wires to be removed for proper reassembly. CAUTION: Wiring errors cause
improper and dangerous operation.
• The convection blower is located at the bottom of the appliance at the back. Remove the
three screws holding the blower.
• Lift the blower out and disconnect the wires from the blower.
• Replace in reverse order.
REPLACING OPTIONALCONVECTION BLOWER
SHOULD YOUR GLASS BREAK...
In the event your glass cracks or breaks, it must be replaced by the exact same size and mate-
rial. It is made from high temperature clear TEMPERED material. See replacement parts list
and contact your nearest Archgard dealer. Refer to page 17 for removal details.
• Remove old door and carefully discard the broken parts (the old door parts are not field
serviceable).
• Replace with a new Factory assembled door assembly (part number 821-0050). This new
door assembly will simply “clip” onto the body of the appliance (as the old door did) no tools
are required to complete this operation.
• Do not substitute any components or materials on this door assembly.
• Replace the door (carefully making sure both latches are closed).
SERVICING Cont...
CONVERTIBLE PILOT ORIFICE
The pilot assembly is convertible to the type
of gas being used; simply unscrew the body
by using a 7/16” (11 mm) wrench & turn a 1/4
open then push the small metal tab across to
the other side of the body and retighten. Call
your local Authorized Archgard Dealer to
purchase the correct fuel conversion kit
for your gas appliance.
7/16” (11
mm)