Specifications

27-DVIM22 16
Before placing the appliance into the fireplace, check the hearth of the fireplace to see if it is level
with the front of the fireplace. If it is not, measure the depth of the hearth. Loosen the three screws of
the leveling “L” bracket at the back of the appliance. Lower it to the measurement obtained and
tighten the screws.
APPLIANCE DESCRIPTION
ELECTRICAL CONNECTIONS
The 27-DVIM22 comes complete with an thermally controlled variable speed fan equipped with a
solid state speed control.
Do not cut or remove the grounding prong from this plug.
NOTE: This appliance, when installed, must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Code, ANSI / NFPA 70, or the
Canadian Electrical code, CSA C22.1.
TOP VIEW
Intake Exhaust
FRONT VIEW
LEVELING THE 27-DVIM22
Rear Level
On/Off
Rocker
Switch
Front Level
Located slightly in from the front edge of the fireplace is the new level-
ing feature. Leveling bolts can be installed to enable you to raise the
front of the firebox if necessary. If you need higher adjustment you only
need to change to a longer bolt. If no rise is required simply leave
empty.
Fig. 16-A
Fig. 16-B
Fig. 16-C
Fig. 16-D
Ceramic
Glass w/
standard
black door
Surround
Faceplate
Shown with 27-SKSBS Trim