Data Sheet

Quartz Module Datasheet
Document Version 1.1 Arçelik A.Ş. 22
Sensitivity: Confidential
The module must be installed in the host equipment such that at least 20cm is maintained
between the antenna and users’ body; and if RF exposure statement or module layout is
changed, then the host product manufacturer required to take responsibility of the module
through a change in FCC ID or new application. The FCC ID of the module cannot be used
on the final product. In these circumstances, the host manufacturer will be responsible
for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
Antennas
Antenna specification are as follows:
• Type: PCB Antenna
• Gain: 4.59 dBi
This device is intended only for host manufacturers under the following conditions:
• The transmitter module may not be co-located with any other transmitter or antenna.
• The module shall be only used with the external antenna(s) that has been originally tested
and certified with
this module.
• The antenna must be either permanently attached or employ a ‘unique’ antenna coupler.
As long as the conditions above are met, further transmitter test will not be required.
However, the host
manufacturer is still responsible for testing their end-product for any additional compliance
requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.).
Label and Compliance Information
Host product manufacturers need to provide a physical or e-label stating “Contains FCC ID:
2A3WF-QUARTZ04” with their finished product.
Information on test modes and additional testing requirements
• Operation Frequency:
– WiFi: 2412 ~ 2462 MHz
– Bluetooth: 2402 ~ 2480 MHz
• Number of Channel:
– WiFi: 11
– Bluetooth: 40
• Modulation:
– WiFi: DSSS; OFDM