Data Sheet

Quartz Module Datasheet
Document Version 1.1 Arçelik A.Ş. 19
Sensitivity: Confidential
8 FLASH PROGRAMMING
ESP32 PROG tool is used for ESP32 flash programming.
Programming steps:
1. Quartz Module “KN2” connector and ESP-PROG “Prog 1.27mm” connector
should be connected together with 6-pin cable.
2. The two jumpers indicated on the ESP-Prog picture must be installed.
3. Software must be installed by using the .bat file released by IOT
team
Figure 11: ESP Programmer