Product Manual

PUMP INSTRUCTIONS FOR CP12 & CP20
1. Place the handle on the release valve and
rotate clockwise until the valve is closed
(hand tighten only).
3. To release pressure, remove the pump handle from
the cradle and use the handle to slowly turn the
release valve counterclockwise. The power unit
cylinder will retract and the press cradle will return
to the stored position.
2. Place the pump handle in the cradle.
Move pump handle up and down to
lower the carriage and apply force
to the item being pressed.
WARNING
Never wire, clamp or otherwise disable the
lift control valve to function by any means
other than by using the operator’s hand.
TO OPERATE MANUALLY
CP301 can be operated manually or with pneumatic/ hydraulic assist. See step 8 (#1, 2, & 3) for manual operating instructions.
TO OPERATE WITH PNEUMATIC/ HYDRAULIC ASSIST
After step 7 (#9): Ensure the oil level is just below the oil filler plug hole. Re-install the oil filler plug.
Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the lift control valve.
Connect to air supply and operate for 3 seconds to evenly distribute lubricant. Check to ensure that the pump operates smoothly before putting into service.
Replace worn or damaged parts and assemblies as needed with manufacturer’s authorized replacement parts.
PUMP INSTRUCTIONS FOR CP301
Note: When not in use, store power unit with the piston in the fully retracted position and the release valve closed.
1. Place the handle on the release valve
and rotate clockwise until the valve
is closed (hand tighten only).
3. To end pneumatic operation, release
the grip on the air hose trigger.
2. To begin pneumatic operation, squeeze air
hose trigger until ram comes into contact
with the item to be pressed.
Air Hose Trigger
We want to know if you have any problems
with our products. If you are missing any parts
or find any damage, call Arcan directly, and we
will remedy the situation. Please do not call
the store where you purchased this product.
Phone: [phone]
Email: [e-mail]
CP12 CP20 & CP301 Operation Manual 6