AM and FM Tuner User Manual

T61
8
Using the CR-389 remote control
FM DAB
PROG DISP
RPT
MODE BAND
1–92–10 3–11
FM
DAB
SEL
TUNER
CR-389
CD
AMPLIFIER
VCRDVD TAPEAV
TUNERCDAUXPHONO
ENTER
SP1
SP2
DISP
MENU DISP
4–12
5–13 6–14 7–15 8–16
FM/DAB
Ensure that the FM mode is selected using
the FM/DAB toggle button. The FM LED above
the FM/DAB button is lit briefl y when FM is
selected.
Preset memory buttons
These buttons allow access to individual preset stations.
To select a preset press the corresponding keypad button.
For presets 9–16, press and hold the corresponding
preset button for one second. Use the Tune buttons to
access FM memory presets 17 to 30.
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on the
tuner (where the IR receiver is located), or the remote
control may not work.
Tune buttons
These buttons enable you to scroll through the
stored station selections one at a time, or to tune
up or down, depending on the Tuning mode.
BAND
This button toggles between FM and AM.
MODE (Tuning mode)
This button toggles between
PRESET and TUNE modes.
Amplifi er controls
These buttons offer basic control over Arcam
amplifi ers, such as the A65, A75 or A85.
CD player controls
These buttons offer basic control over Arcam CD
players, such as the CD62, CD72 or CD92.
MENU (RDS mode)
This button scrolls through RDS modes, when available.
DISP (Display)
This button allows you to dim or switch off the tuner display.
STANDBY
This button switches the tuner (and the amplifi er if
appropriate) between ‘On’ and ‘Standby’.
NOTE: DAB (Digital Audio Broadcast) refers to Arcam
DAB tuners such as model DT81.
T61 issue2.id 05/30/02, 7:43 PM8