Power Amplifier P35
Safety guidelines 9. Power sources SAFETY INSTRUCTIONS Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance. This product is designed and manufactured to meet strict quality and safety standards. However, you should be aware of the following installation and operation precautions: 10.
+ R/CH1 – + L/CH2 – + CTR/CH3 – SP2 SP2 4 – 16 OHMS TRIG OUT 230V VOLTAGE SELECT POWER INLET SP1 REMOTE IN + R/CH1 – AUDIO LINK SP1 R + L/CH2 – CTR/CH3 4 – 16 OHMS L IN AUDIO IN OUT + CTR/CH3 – OUT Optional Third Channel Module – provides a third 90W channel suitable for Home Cinema or multi-channel audio use.
Using your P35 power amplifier P35 POWER AMPLIFIER SP1 SP2 POWER POWER (AND POWER INDICATOR LIGHT) SP1 AND SP2 Switches the unit on and off. The light indicates the status of the amplifier. These buttons allow you to select and deselect the main (SP1) and secondary (SP2) sets of speakers attached to your amplifier. An indicator light shows which set of speakers are currently selected.
Bi-wiring and bi-amping loudspeakers BI-AMPING YOUR SYSTEM The performance of your system can be further enhanced over that achieved with bi-wiring, by extending the principle one stage further to include separate amplification for the low and high frequency drive units in each loudspeaker enclosure. WARNING: Do not make any connections to your amplifier while it is switched on or connected to the mains supply.
Technical specifications A32 P35 Continuous power output (20Hz—20kHz at 0.5% THD), per channel Both channels, 8Ω, 20Hz—20kHz 100W Single channel, 8Ω, 20Hz—20kHz 150W Both channels, 4Ω, 20Hz—20kHz 140W Single channel, 4Ω, at 1kHz 200W Three channels, 8Ω, 20Hz—20kHz – Harmonic distortion, 80% power, 8Ω at 1kHz 0.
Before returning your amplifier for service, please check the following: Note that because of the high output voltage from a CD player, it is possible to drive the A32 at full power even though the volume is not set at maximum. SOUND CUTS OUT FOR NO REASON If the temperature of the internal heatsink rises above a safe level, then a thermal cutout inside the amplifier will operate.
