H A N D B O O K / MANUEL/HANDBUCH/HANDLEIDING CD73 Arcam CD73 Compact Disc player English Lecteur de Disque Compact Arcam CD73 Français Arcam CD73 Compact Disc-Spieler Deutsch Arcam CD73 CD-speler Nederlands
Safety guidelines CAUTION ATTENTION RISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam CD73 compact disc player. The CR224 remote control handset supplied with this equipment is also described. Safety Safety guidelines are set out on the inside front cover of this handbook. Many of these items are common sense precautions, but for your own safety, and to ensure that you do not damage the unit, we strongly recommend that you read them.
Installation AUDIO – OUT 1 2 POWER INLET L VOLTAGE SELECT L R DIGITAL OUT COAXIAL OPTICAL R IR-IN 12V TRIGGER IN 120V/230V 1 2 4 5 3 6 7 Positioning the unit Always place the CD player on a level, firm surface. Placing your player on a set of dedicated sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations created within the player itself. You will generally hear some sonic improvements, which makes this an extremely cost-effective upgrade.
English Using your CD player COMPACT DISC PLAYER CD73 24 BIT DAC LOAD PLAY 2 POWER STOP PAUSE 3 4 5 6 TRACK POWER 7 1 1 Press this button to switch the CD player on and off. When first powered up with no CD installed the display shows ‘No disc’. LOAD 2 To install a CD, press LOAD (or OPEN on the remote control). The CD tray opens – it accepts 12cm and 8cm discs. Place the CD in the tray with the label facing uppermost.
Using the CR224 remote control PROG (Program) You can program a selection of up to 24 tracks from a disc to play in any order. Select a track by using the and buttons, then press PROG to program the track into memory (‘PROGRAM’ appears on the display to indicate that you have started programming a sequence). Repeat these steps to program the remaining tracks in your selection. Alternatively, press PROG once and enter your track selection using the 0–9 keypad.
English English Remote-control codes The following table gives the IR-commands accepted by the CD73. Items shown in italics reference the buttons on the supplied CR224 remote control. The items not in italics are additional commands accepted by the CD73. Power commands Command Decimal Code Power toggle 20–12 Power-on 20–123 Power-off 20–124 Playback control commands Command Decimal Code Track number ‘n’, (e.g., 1) 20–n (e.g.
Technical specification Digital to Analogue conversion 24-bit multilevel Delta-Sigma DAC Laser pick-up 3 beam Laser wavelength 780nm Numerical aperture 0.45 Signal to noise ratio 112dB Harmonic distortion (1kHz) 0.003% Frequency response (±0.5dB) 0.3Hz–20kHz Output level (0dB) 2.2Vrms Output impedance 150Ω Minimum recommended load 5kΩ Physical Dimensions W430 x D290 x H85mm Weight 4.6kg nett/6.
English Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor.
