HANDBOOK CD 6 2 Arcam CD62 Compact Disc player
Safety guidelines Safety instructions This product is designed and manufactured to meet strict quality and safety standards. However, you should be aware of the following installation and operation precautions: 1. Take heed of warnings and instructions You should read all the safety and operating instructions before operating this appliance. Retain this handbook for future reference and adhere to all warnings in the handbook or on the appliance. 2.
Using this handbook This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam CD62 compact disc player. The CR224 remote control handset supplied with this equipment is also described, as it applies to operating the CD62. Note that this product is not upgradeable to a CD72, CD92, or any other model in the Arcam range. Safety Safety guidelines are set out on the inside front cover of this handbook.
Installation Positioning the unit Connecting to a power supply Always place the CD player on a level, firm surface. Placing your player on a set of dedicated sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations created within the player itself. You will generally hear some sonic improvements, which makes this an extremely cost-effective upgrade.
Using your CD player COMPACT DISC PLAYER CD62 24 BIT DAC LOAD 2 POWER PLAY 1 2 INDEX MIN 1 TRACK POWER 7 1 7 To start a CD with a track other than the first, press to locate the desired track. or or . The To select another track during play, press once track is played automatically after selection. Pressing returns to the start of the current track. To select the previous track, press twice quickly. To go back two tracks, press three times, and so on.
Using the CR224 remote control PROG (Program) You can program a selection of up to 24 tracks from a disc to play in any order. Select a track by using the and buttons, then press PROG to program the track into memory (‘PROGRAM’ appears on the display to indicate that you have started programming a sequence). Repeat these steps to program the remaining tracks in your selection. Alternatively, press PROG once and enter your track selection using the 0–9 keypad.
Technical specification Digital to Analogue conversion 24-bit multilevel Delta-Sigma DAC Laser pick-up Laser wavelength Numerical aperture Dynamic range Signal to noise ratio (CCIR) Harmonic distortion (0dB, 1kHz) Frequency response (±0.5dB) Output level (0dB) Output impedance Minimum recommended load 3 beam 780nm 0.45 106dB >100dB <0.005% 5Hz–20kHz 2.3Vrms 120Ω 5kΩ Physical Dimensions Weight Power consumption W430 x D290 x H84mm 4.6kg nett/6.
Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor.
