User's Manual

Page : 7
CONFIDENTIAL Arcadyan Corporation Ver.0.1
This module is intended for OEM integrator only. The OEM integrator is
responsible for the compliance to all the rules that apply to the product into
which this certified RF module is integrated.
Additional testing and certification may be necessary when multiple modules are used.
OEM integrators are responsible for ensuring that the end-user has no manual
instructions to remove or install module
The module is limited to installation in mobile or fixed applications, according to Part
2.1091(b).
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least
20cm separation with the antenna while this end product is installed and operated. The
end user has to be informed that the FCC radio-frequency exposure guidelines for an
uncontrolled environment can be satisfied.
The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment.
If the labelling area is small than the palm of the hand, then additional FCC part 15.19
statement is required to be available in the users manual: This device complies with Part
15 of FCC rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX
FCC ID: RAXWN9711 ".
If the labelling area is larger than the palm of the hand, then the following FCC part 15.19
statement has to also be available on the label: This device complies with Part 15 of FCC
rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.