User Manual User Manual WN7522C 1 802.11n Single band WLAN module V1.
User Manual Table of Contents Chapter 1 Introduction ________________________________________________________ 4 1. Introduction ________________________________________________________ 4 1.1 Product Features____________________________________________________ 4 1.2 Applications _______________________________________________________ 4 Chapter 2 Hardware _______________________________________________________ 5 2.1 General Overview __________________________________________________ 5 2.
User Manual Revision History Edition # Reason for revision V 0.1 ♦ Initial Document V1.
User Manual Chapter 1 Introduction 1. Introduction WN7522C 1 is a single band wireless 802.11n USB module for Blu-ray players and other multi-media devices. It enables multi-media devices to connect onto 802.11n WLAN network and attain data communication speeds up to 300 megabits-per-second (Mbps). It is also backward compatible to the existing installed base 802.11b/g network. 1.1 Product Features ♦ High speed for wireless LAN connection, RX up at 300 Mbps data rate.
User Manual Chapter 2 2.1 ♦ Hardware General Overview USB 2.0 Interface and 802.11 n chipset-on-board design. 2.2 Hardware Architecture Broadcom 43231 single chip USB2.0 2.3 ♦ Main Chipset Information BCM43231: MIMO MAC + Baseband processor and RF with integrated 2.4GHz PA 2.4 PCB dimension: • PCB Dimensions: 68mm x 21.8mm x 1mm (L x W x H) • PCBA net weight: around 6g 2.5 Host Interface • USB 2.0 interface (4-pin connector) 2.
User Manual Chapter 3 Software 3.1 Operating System Supported ♦ Windows 2000, XP, Vista ♦ Linux Driver 3.2 Wireless Mode Supported ♦ AP (Infrastructure) Client mode 3.3 Security ♦ AP (Infrastructure) mode supports ♦ Static WEP that support both 64 and 128 bit keys. ♦ WPA(TKIP) with PSK ♦ Ad-hoc mode supports ♦ None (plaintext) ♦ Static WEP that supports both 64 and 128 bit keys.
User Manual Chapter 4 Appearance Figure 4-1 below illustrates the mechanic drawing of the module with 4-pin USB connector.
User Manual Chapter 5 ♦ Specifications Frequency Band: Draft 802.11n Radio: 2.4 GHz 802.11g Radio: 2.4 GHz 802.11b Radio: 2.4 GHz USA – FCC Canada – IC Europe – ETSI France Japan – STD-T66/STD-33 ♦ Operating Channels: IEEE 802.11b/g/n compliant: 11 channels (US, Canada) 13 channels (ETSI) 4 channels (France) 14 channels (Japan) ♦ Transmit Power and Sensitivity: TX Output Power:(Typical) 11b 16.5 +/- 1 dBm 11g 16.5 +/- 1 dBm@54Mbps 11n 15.
User Manual QPSK@12/18Mbps 16-QAM@24Mbps 64-QAM@48/54Mpb and above ♦ Current consumption(5V DC): TX: 380mA Max, @MCS7, 40MHz RX: 350mA Max, @MCS15, 40MHz Power Saving: < 50mA Radio OFF mode: < 100mA ♦ ♦ ♦ Operating Temperature: 0 ~ 40 oC ambient Storage Temperature: -10 ~ 70 oC ambient Humidity: 5 ~ 90% and must be non-condensing ♦ Regulation and certification compliance available: ♦WHQL ♦ETSI/CE ♦ESD: EN61000-4-2, which specifies 4kV contact and 8kV air discharge.
User Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
User Manual integrates this module. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satisfied. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
User Manual Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numerique de la class B est conforme a la norme NMB-003 du Canada.
User Manual modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. IC statement is required to be available in the users manual: This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
User Manual References ♦ IEEE 802.11b Standard Specification ♦ IEEE 802.11g Standard Specification ♦ IEEE 802.11n draft Standard Specification The drawings, specifications and the data contain herein are the exclusive property of Arcadyan Technology Corp. issued in strict confidence and shall not, without the prior written permission of Arcadyan Technology Corp.
