User Manual

51
Appendix
Gigaset USB Adapter 54 / English / A31008-E505-B104-1-19 / appendix.fm / 26.02.2004
The Gigaset USB
Adapter 54 does
not work properly
You have checked all of the causes specified above, and still no
communication is possible.
ì Deinstall the software and install it again as described in
Chapter "Installing the Gigaset USB Adapter 54" on page 7.
You cannot
establish a
connection to the
Access Point
If you cannot set up a connection between your Gigaset USB
Adapter 54 and an Access Point, try one or more of the
following:
ì Make sure that the physical connection of the Access Point
operates reliably.
ì Make sure that the same SSID is used for the Gigaset USB
Adapter 54 and the Access Point.
ì Check whether the security settings configured for the
Gigaset USB Adapter 54 match those for the Access Point,
e. g. the same key for WEP encryption.
ì Check whether your access to the Access Point is blocked by
other security measures, e. g. by a MAC filter or filter for
IP addresses.
ì Make sure that the IP address and the subnet mask are
correctly configured in the IP Settings tab.
As a rule, it is necessary to assign dynamic IP addresses
when operating a network in infrastructure mode.
Installation
cancelled under
Windows 2000
If the following error message appears when installing the
Gigaset USB Adapter 54 under Windows 2000: "1608: Unable
to create InstallDriver instance" and the installation is cancelled,
the cause is that the Microsoft Network Client component is
missing.
To install the Microsoft Network Client:
ì Select Start > Settings > Control Panel > Network and
Dial-up Connections.
ì Right-click on LAN Connection, and select Properties.
ì Then click on the following Install > Client > Add > Client
for Microsoft Networks > OK.
The Microsoft Network Client component is now installed.
ì Restart your PC to apply the change.
ì Install the software, see Chapter "Installing the Gigaset USB
Adapter 54" on page 7.
Problem Causes and remedies