User's Manual

802.11g 54Mbps USB Adapter User Guide
Note: If you are connecting the 802.11g 54Mbps USB Adapter to a 1.1 USB port, you
may see a message informing you that a Hi-Speed USB device is being connected to
a USB port that is not Hi-Speed. This will not affect the installation procedure.
Step One: Install your software and drivers
Insert your U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and
type D:\setup (if your CD-ROM drive uses a different letter, type that letter in place of
"D") and click OK.
The Installation CD Graphic User Interface (GUI) will appear on your screen. If
prompted, select your preferred language.
Read the license agreement and click Yes.
Select the 802.11g 54Mbps USB Adapter and click Software. Click Wireless USB
Adapter Utility and Drivers. Follow the on-screen instructions to finish the installation
procedure.
Windows Me: If you are prompted, restart your computer and continue to follow the
on-screen instructions.
Step Two: Install the 802.11g 54Mbps USB Adapter to your
computer
When you are prompted, insert the 802.11g 54Mbps USB Adapter into an available
USB port on your computer.
file:///C|/Arcadyan/USR/SW/English/three.html 第 2 頁 / 共 6 2004/9/15 下午 05:34:54