User's Manual

1041400-0001 Revision B April 6, 2017

Setting Up Your Hughes Wi-Fi Booster With Your HT2000W Modem

Check the box contents

Before you begin, make sure the box has the contents shown in Figure 1.

Figure 1: Box contents

Congure the Booster

For the initial setup, you must be near the HT2000W. To congure the Hughes

Wi-Fi Booster:

1. Plug the Booster into a power outlet using the provided power supply.

Push the Power button ( ) on the back of the device to power it on.

2. Lay the Booster ho

rizontally, as shown in Figure 2, so you can clearly see

the LED on the bottom of it. Wait for the LED to turn red. This may take 1

minute. The LED will turn other colors before turning red.

Figure 2: Red LED – Booster is ready for conguration

3. Connect the Booster to the HT2000W with the provided LAN cable.

Connect the cable from the yellow LAN port on the device to any LAN port

on the H

T2000W. See Figure 3.

Figure 3: Connect the Booster to the HT2000W

Power supply

Hughes Wi-Fi Booster

LAN cable

150200199500J R01 AMD

PAGE 1
Setting Up Your Hughes Wi-Fi Booster With Your HT2000W Modem Check the box contents Before you begin, make sure the box has the contents shown inFigure 1. Hughes Wi-Fi Booster Power supply Figure 2: Red LED – Booster is ready for configuration 3. Connect the Booster to the HT2000W with the provided LAN cable. Connect the cable from the yellow LAN port on the device to any LAN port on the HT2000W. See Figure 3.
PAGE 2
4. Watch the LED on the Booster as the device automatically syncs with the HT2000W. The LED will blink light purple for about 1 minute while this happens. See Figure 4. What do the different LED colors mean? Table 1: LED color meanings LED color Figure 4: Purple LED – Booster is syncing 5. When the LED is solid blue, the sync is complete. SeeFigure 5. Definition Solid blue Good Wi-Fi connection. No action required. Flashing blue Connecting to the Wi-Fi network.