User's Manual

III
LED Indicators
ETH2/ETH1 (Gigabit Ethernet Port)
On Flashing
Ethernet connection has been
established.
The indicated Gigabit LAN port is
sending or receiving data.
5G (IEEE 802.11a/n/ac)
On Flashing
5GHz wireless link has been
established.
Data is transmitted via 5GHz
wireless link.
2.4G (IEEE 802.11b/g/n)
On Flashing
2.4GHz wireless link has been
established.
Data is transmitted via 2.4GHz
wireless link.
Run (Power)
On Flashing
Powered on
The access point is
establishing a wireless link via
wireless access controller. It
connects to your network operation
center.
Connection Interface
Gigabit Ethernet Ports (RJ-45)
 ETH1/ PoE, ETH2 –
 Connect devices on your local area network to these ports (i.e., a PC,
hub, switch or IP set top box).
 This access point supports power over Ethernet (PoE). It can be
powered by PoE with long length cabling. Connect the PoE port to
your gateway or a switch.
 USB Port – Connect your USB device to this port.
 RESET Button – Use this button to reset the power and restore the factory
default settings.
 DC 12V Power Inlet – Connect the included power adapter to this inlet.
II


 