User's Manual

Frequently Asked Questions 69
1 Remove power from the Access Point and connect the admin computer to the
LAN port.
2 Run the Discovery application included on the product CD.
3 This will connect you to the Microcode Recovery utility in the Access Point.
4 Follow the on-screen instructions. Enter the path and filename of the software
image file.
5 When the upload has completed, the Access Point will restart, run the self-test
and, if successful, resume normal operation. The Alert LED will go out.
6 Reconnect your Access Point to your network.
If the Access Point does not resume normal operation following the upload, it
may be faulty. Contact your supplier for advice.
Frequently Asked
Questions
How do I reset the Access Point to Factory Defaults?
See “
Forgotten Password and Reset to Factory Defaults” on page 66.
How many wireless clients does the Access Point support?
A maximum of 128 wireless clients are supported.
There is a single LAN ports on the Access Point. How are additional
computers connected?
You can expand the number of connections available on your LAN by
using hubs, switches and wireless access points connected to the
Access Point. 3Com wireless access points and OfficeConnect hubs
and switches provide a simple, reliable means of expanding your
network; contact your supplier for more information, or visit:
http://www.3com.com/
Where can I download software upgrades for the Access Point?
Upgrades to the Access Point software are posted on the 3Com support
web site, accessible by visiting:
http://www.3com.com.
What other online resources are there?
The 3Com Knowledgebase at: