User's Manual

Front Panel 15
Flashing slowly - The Access Point has completed the Reset to Factory
Defaults process, and is waiting for you to release the reset button. The Access
Point will then enter the start-up sequence and resume normal operation.
If you have used the reset button to reset the unit to Factory Defaults, follow
steps 5 to 6 in “
Forgotten Password and Reset to Factory Defaults” on
page 66
.
Continuously on - A fault has been detected with your Access Point during the
start-up process. Refer to Chapter 6
“Troubleshooting”.
2Power LED
Green
Indicates that the Access Point is powered on.
3 LAN Status LED
Green (100Mbps link) / yellow (10Mbps link)
If the LED is on, the link between the port and the next piece of network
equipment is OK. If the LED is flashing, the link is OK and data is being
transmitted or received. If the LED is off, nothing is connected, the connected
device is switched off, or there is a problem with the connection (refer to
Chapter 6
“Troubleshooting”). The port will automatically adjust to the
correct speed and duplex.
4 Wireless LAN (WLAN) Status LEDs
Yellow
There are two LEDs, one for 11a and one for 11g. If an LED is on it indicates
that wireless networking is enabled. If the LED is flashing, data is being
transmitted or received. If the LED is off, the Wireless LAN has been disabled
in the Access Point, or there is a problem. Refer to Chapter 6
“Troubleshooting”.