User's Manual

Using the Web-Based Advanced User Interface
45
section
2
1
3
4
5
6
7
8
9
10
11
WPA/WPA2 Setup
1.
Select “WPA/WPA2” or “WPA2 only” from the “Allowed Client Type”.
2.
Select “Pre-shared key” as the authentication type.
3.
Enter your pre-shared key. This can be from eight to 63
characters and can be letters, numbers, or symbols. This same
key must be used on all of the clients that you set up. This
pre-shared key will allow users full access to your network
including shared files and printers.
4.
Click “Apply Changes” to finish. You must now set all clients to
match these settings.
5.
Enter your pre-shared key for guest access. This can be from
eight to 63 characters and can be letters, numbers, or symbols.
This guest pre-shared key allows users only Internet access.
6.
Click “Apply Changes” to finish. You must now set all clients to
match these settings depending on the type of access you want
them to have.