User's Manual

DATA SHEET
SE2565T: 2.4 GHz High Power Wireless LAN Power Amplifier
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
202424A • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • September 25, 2012 3
Absolute Maximum Ratings
These are stress ratings only. Exposure to stresses beyond these maximum ratings may cause permanent damage
to, or affect the reliability of the device. Avoid operating the device outside the recommended operating conditions
defined below. This device is ESD sensitive. Handling and assembly of this device should be at ESD protected
workstations.
Symbol Definition Min. Max. Unit
VCC Supply Voltage on VCC -0.3 4.0 V
VIN DC input on EN -0.3 3.6 V
TX RF Input Power with RF Out terminated in 50Ω - 12.0 dBm
TA Operating Temperature Range -40 85 °C
TSTG Storage Temperature Range -40 150 °C
ESD
HBM
JEDEC JESD22-A114
all pins
- 1,000 V
Recommended Operating Conditions
Symbol Parameter Min. Typ. Max. Unit
TA Ambient temperature -40 25 85 °C
VCC Supply voltage, relative to GND = 0 V 2.9 3.3 3.6 V
DC Electrical Characteristics
Conditions: VCC = EN = 3.3 V, TA = 25 °C, as measured on Skyworks Solutions’ SE2565T-EV1 evaluation board
(de-embedded to device), all unused ports terminated with 50 ohms, unless otherwise noted
Symbol Parameter Conditions Min. Typ. Max. Unit
ICC-G Total Supply Current
POUT = 23 dBm, 54 Mbps
OFDM signal, 64QAM
- 410 - mA
ICC-B Total Supply Current
P
OUT
= 26 dBm, 11 Mbps
CCK signal, BT = 0.45
- 450 - mA
ICC_OFF Total Supply Current EN = 0 V, No RF Applied - 10 100 μA
Logic Characteristics
Conditions: VCC = EN = 3.3 V, TA = 25 °C, as measured on Skyworks Solutions’ SE2565T-EV1 evaluation board
(de-embedded to device), all unused ports terminated with 50 ohms, unless otherwise noted.
Symbol Parameter Conditions Min. Typ. Max. Unit
VENH Logic High Voltage (Module On) - 1.8 - VCC V
VENL Logic Low Voltage (Module Off) - 0 - 0.4 V
IENH Input Current Logic High Voltage - - 300 - μA
IENL Input Current Logic Low Voltage
V
ENL
= 0.4V
- 1 50 μA