User's Guide
Table Of Contents
- 01 /
- Introduction
- 1.0/ Package Contents
- 1.1/ System Requirements
- 1.2/ Features
- 1.3/ Getting to Know Your Fios Home Router
- 02 /
- CONNECTING YOUR Fios Home Router
- 2.0/ Setting up Your Fios Home Router
- 2.1/ Expanding Wi-Fi coverage
- 2.2/ Computer Network Configuration
- 2.3/ Main Screen
- 03 /
- WIRELESS SETTINGS
- 3.0/ Overview
- 3.1/ Wireless Status
- 3.2/ Basic Settings
- 3.3/ Advanced Settings
- 3.4/ Channel Settings
- 3.5/ Guest Network
- 04 /
- CONFIGURING Network SETTINGS
- 4.0/ Accessing Network Settings
- 4.1/ Using Network Settings
- 05 /
- USING NETWORK CONNECTIONS
- 5.0/ Accessing Network Connections
- 5.1/ Network (Home/Office) Connection
- 5.2/ Wireless Access Point Connection
- 5.3/ Ethernet Connection
- 5.4/ Broadband Connection
- 06 /
- SETTING PARENTAL CONTROLS
- 6.0/ Activating Parental Controls
- 6.1/ Rule Summary
- 07 /
- CONFIGURING SECURITY SETTINGS
- 7.0/ Firewall
- 7.1/ Access Control
- 7.2/ Port Forwarding
- 7.3/ Port Triggering
- 7.4/ DMZ Host
- 7.5/ Static NAT
- 7.6/ IPv6 Pinholes
- 08 /
- CONFIGURING ADVANCED SETTINGS
- 8.0/ Using Advanced Settings
- 8.1/ Utilities
- 8.2/ Network Settings
- 8.3/ Date And Time
- 8.4/ DNS Settings
- 8.5/ Monitoring
- 8.6/ System Settings
- 09 /
- TROUBLE
- SHOOTING
- 9.0/ Troubleshooting Tips
- 9.1/ Frequently Asked Questions
- 10 /
- SPECIFICATIONS
- 10.0/ General Specifications
- 10.1/ LED Indicators
- 10.2/ Environmental Parameters
- 11 /
- NOTICES
- 11.0/ Regulatory Compliance Notices
BROADBAND CONNECTION
2. Configure the following settings, as needed.
GENERAL
Verify the following information:
• Status - displays the connection status of the network.
• Network – displays the type of network connection.
• Connection Type - displays the type of connection
interface.
• Physical Address - displays the physical address of the
network card used for the network.
• MTU - specifies the largest packet size permitted for
internet transmissions:
– Automatic: sets the MTU (Maximum Transmission
Unit at 1500).
– Automatic by DHCP: sets the MTU according to the
DHCP connection.
– Manual: allows you to manually set the MTU.
COAX LINK
• Privacy - to set Privacy, select the Enabled check box.
This causes all devices connected to the coaxial cable to
use the same password. This is recommended. To set the
password, enter the Coax Link password in the Password
field.
• To enable or disable the Coax link, click Disable or
Enable.