User's Guide
Table Of Contents
- 01 /
- Introduction
- 1.0/ Package Contents
- 1.1/ System Requirements
- 1.2/ Features
- 1.3/ Getting to Know Your Fios Home Router
- 02 /
- CONNECTING YOUR Fios Home Router
- 2.0/ Setting up Your Fios Home Router
- 2.1/ Expanding Wi-Fi coverage
- 2.2/ Computer Network Configuration
- 2.3/ Main Screen
- 03 /
- WIRELESS SETTINGS
- 3.0/ Overview
- 3.1/ Wireless Status
- 3.2/ Basic Settings
- 3.3/ Advanced Settings
- 3.4/ Channel Settings
- 3.5/ Guest Network
- 04 /
- CONFIGURING Network SETTINGS
- 4.0/ Accessing Network Settings
- 4.1/ Using Network Settings
- 05 /
- USING NETWORK CONNECTIONS
- 5.0/ Accessing Network Connections
- 5.1/ Network (Home/Office) Connection
- 5.2/ Wireless Access Point Connection
- 5.3/ Ethernet Connection
- 5.4/ Broadband Connection
- 06 /
- SETTING PARENTAL CONTROLS
- 6.0/ Activating Parental Controls
- 6.1/ Rule Summary
- 07 /
- CONFIGURING SECURITY SETTINGS
- 7.0/ Firewall
- 7.1/ Access Control
- 7.2/ Port Forwarding
- 7.3/ Port Triggering
- 7.4/ DMZ Host
- 7.5/ Static NAT
- 7.6/ IPv6 Pinholes
- 08 /
- CONFIGURING ADVANCED SETTINGS
- 8.0/ Using Advanced Settings
- 8.1/ Utilities
- 8.2/ Network Settings
- 8.3/ Date And Time
- 8.4/ DNS Settings
- 8.5/ Monitoring
- 8.6/ System Settings
- 09 /
- TROUBLE
- SHOOTING
- 9.0/ Troubleshooting Tips
- 9.1/ Frequently Asked Questions
- 10 /
- SPECIFICATIONS
- 10.0/ General Specifications
- 10.1/ LED Indicators
- 10.2/ Environmental Parameters
- 11 /
- NOTICES
- 11.0/ Regulatory Compliance Notices
21
/ CONNECTING YOUR
FIOS HOME ROUTER
verizonwireless.com | ©2019 Verizon Wireless. All Rights Reserved.
• If connecting the WAN using coaxial cable,
locate a coaxial cable and connect one end
to the coax port on the back of your router.
Connect the other end of the coaxial cable to
a coax wall jack.
Tighten the coaxial cables by hand until snug.
Tightening the coaxial cable should not require
a wrench.
4. Plug the power cord into the power port on the back of your
Fios Home Router and then into a power outlet. The router
automatically turns on as soon as power is plugged in.
Important: Wait until the Router Status LED on the front of the
Fios Home Router stops flashing and is solid white. If the light
turns red, check the steps in the Troubleshooting section of this
user guide.
2.0b/ STEP 2 - CONNECT YOUR NETWORK DEVICE TO YOUR
FIOS HOME ROUTER
If connecting a device using Ethernet (preferred for initial setup):
• Plug one end of an Ethernet cable into one of the four yellow
Ethernet ports on the back of your Fios Home Router.
• Plug the other end of the Ethernet cable into the Ethernet port of
your network device.