User Manual

4 Configuring the Base Station
Base Station User Guide 45
3. Press the UPc or DNd arrow buttons to increment or decrement the value. Select a
value in the range 2 – 135 dBmV.
4. When you reach the desired value, press the ENTER button.
The LCD displays an Entry Accepted response.
To change the Upconverter’s Frequency using the Upconverter’s LCD:
1. Depress the
UPc or DNd arrow navigation keys to scroll through the advanced
variables screens. The sequence is shown below:
2. Navigate to the MODE screen of the appropriate module. Note that the first
sequence of screens corresponds to Module 1, the second to Module 2, etc.
3. Navigate to the FREQ parameter in the MODE screen.
4. When the LCD displays the screen with the variable to be changed, depress and
hold the central
ENTER button for approximately one second, until a blinking cursor
is displayed.
5. Press the UPc or DNd arrow buttons to increment or decrement the value. The
value changes in 12.5 KHz frequency increments.
6. When you reach the desired value, press the ENTER button.