User Manual

3 Installing the Base Station
Base Station User Guide 35
Figure 19: WMTS Download of Regtree File
Restarting the WMTS
The new RegTree properties will go into effect only after the next WMTS boot up. To
restart the WMTS, click System Reset in the WmtsConfig tool.
Connecting the WMTS to the Backbone Network
To Connect the WMTS to the backbone network:
 Connect the Ethernet port located on the WMTS C&F card to the base station
switch/router port connected to the management backbone network. The Ethernet
port on the C&F card transmits and receives Arcadian Networks network
management information.
 Connect the Ethernet port located on the WMTS downstream module front to the
base station switch/router port connected to the data backbone network. The
Ethernet port located on the downstream module transmits and receives data of
devices outside the Arcadian Networks network, such as SCADA devices, security
devices, and PCs.
; Note: The Cisco router located in the V390iA is considered outside the
Arcadian Networks network.