User Manual

3 Installing the Base Station
Base Station User Guide 31
 CmtsSubnetMask – subnet mask of the WMTS.
 GatewayIPAddress – gateway IP address for the WMTS.
3. To enable SNMP access to the WMTS, change the following entries:
 DevNMAccessIP1 – IP address of Arcadian Networks NMS server.
 DevNMAccessCommunity – SNMP community attribute for authorizing the
NMS.
 DevNMAccessControl1 – the type of access level allowed to the NMS (1-no
access, 2-read only, 3-read&write, 4-read only with traps, 5-read&write with
traps, 6-traps only).
; Note: For proper operation of Arcadian Networks NMS do not change the
DevNMAccessControl1 and DevNMAccessCommunity entries.
4. To add support of a second NMS server, or any other SNMP management tool from
additional server duplicate the three lines: DevNMAccessIP1,
DevNMAccessCommunity1, and DevNMAccessControl1. Change to
DevNMAccessIP2, DevNMAccessCommunity2, and DevNMAccessControl2,
and change the values accordingly.
For northbound NMS, you may want to set the DevNMAccessControl2 entry to
traps only or read-only with traps, to avoid management overhead on the WMTS.
To compile the Regtree file:
1. Compile regtree.txt by executing SETIP.bat, which is located in the same
directory as regtree.txt (see Figure 14). SETIP.bat is a batch file that converts
the regtree.txt text file to a special format readable by the WMTS. The resulting
file is named RegTree.rtr and is placed in the same directory as the regtree.txt.
Figure 14: Location of SETIP.bat