Manual

CLEANING AND CARE

IARNING: ENSURE PISTOL IS UNLOADED BEFORE ATTEMPTING DISASSEMBLY.

'EFER TO SECTION TinED "TO UNLOAD THE PISTOL

If. .

:requency of cleening depends on the frequency of use of the pistol. Accumulation of

lowder fourmg in the breech and chamber area may affect the functioning of the pistol

:ausinp jamming or misfiring. If either of these conditions dnelop, clean the pistol before

Issummg that something is wrong with it.

\0 areas of breech, slide, magazine, chamber and bore should be scrubbed or wiped clean

!Vith a cleaning patch wetted with a powder solvent After aD areas have been thoroughly

:leaned, wipe again with an oiled cloth. .

I'hough these pistols are made of high-quar..y stainless stee~ a rrght coat of surface rust

nay develop over a period of time, especiaOy in areas of high humidity. This is a very thin

lurface coating and can be removed with a rust ~reventive solvent and a clean cloth.

Nhne use of only weD-recognized brands of cJmIIII8fCial ammunition is recommended and.

!Varranted, some foreign brands utilize corrosive pfiners which necessitate a thorouqh

:Ieaning of at least the barrel and sRde with hot water. For cleaning the residue from thIS

Iype of ammunition, use a brass core brush and a stainless steel p1stol cleaning rod with

I Jag tip with new cotton flannel ~atches cut to fit the bote snugly. After cleaning, use

firearm lubricants such as Firepower

FP.10..:

SIGHT ADJUSTMENT

nil pistol may be provided with an adjustable tear sight with both elevation and windage

Idjustments. The adjustment screw should be turned to move the sight blade in the

lirection to which you want the bunet stn'ke point to move. For example, turning the

",indage adjustment screw counterclockwise moves the sight blade to the left and bnpact

If the bullet to the left.

SERVICE

'rior to shipment, each AUTO MAG II pistol is carefuOy inspected and test fired to ensure

hat it is in proper operating condition. Should the pistol require ad'JUstment, repair or

efinishing, we recommend that the pistol be returned directly to the FACTORY SERVICE

JEPARTMENTI There is no other way to be sure that work is performed in a properly

!quipped and staffed faciRty. Fanure to use the factory services wiD resuh in voidmg your

varranty.

:xcept for guns stm under warranty, aD work wDi bear a net minimum charge.

m pistols returned are to be sent unloaded and prepaid. An conect shipments wiD be

efused.

:or best service, always enclose a cover letter with the pistol furnishing serial number,

nodel of pistol, and the nature of the problem or work desired. A statement that the pistol

s "defective" is not adequate and wiD only resuh in unnecessary delays. Try to be as

:pecific as possible.

Wear Safety Glasses and Ear Protection at all times when shooting!