900mm Intergrated Canopy Manual MODEL IRI9WE3 Installation and Operation
IRI6WE3 and IRI9WE3 Installation and Operation Manual Dear Customer, We thank you for choosing this quality appliance and hope you enjoy many years of reliable service. Please ensure this manual is read carefully before installation and use. Keep this manual in a safe and accessible location should future reference be required.
IRI6WE3 and IRI9WE3 Installation and Operation Manual SAFETY WARNINGS • Installation of this Integrated Canopy Rangehood must be carried by a qualified and competent installer. • The manufacturer disclaims and liability for any damage or injury caused as a result of not following instruction of installation contained in this instruction manual. • This Integrated Canopy Rangehood is not intended for use by young children or infirm persons without supervison.
IRI6WE3 and IRI9WE3 Installation and Operation Manual DIMENSIONS Dimensions of IRI6WE3 and IRI9WE3 -3-
IRI6WE3 and IRI9WE3 Installation and Operation Manual INSTALLATION The IRI6WE3 and IRI9WE3 are designed to be installed fully integrated into an overhead cupboard as pictured below. The IRI6WE3 is suited for a 600mm cupboard and the IRI9WE3 suited for a 900mm cupboard. Installation of the IRI9WE3 Integrated rangehood in an overhead cupboard Height Requirement The minimum installation height requirement above the highest point of the cooktop to the rangehood filter should be no less than 65cm.
IRI6WE3 and IRI9WE3 Installation and Operation Manual INSTALLATION - Position of Mounting Bracket The Integrated Rangehood is mounted to the rear of the overhead cupboard. Supplied with the rangehood is a mounting bracket (Fig. 2) Fig. 2 Prior to installation, check the measurement from the screw holes in the mounting bracket to the base of the rangehood.
IRI6WE3 and IRI9WE3 Installation and Operation Manual INSTALLATION – Fitting of Integrated Rangehood Fit 150mm duct spigot (pictured below) with the four 8mm screws provided over the rectangular hole located at the top rear of the integrated rangehood. Fit 150mm flexible ducting (pictured below), supplied, to the ducting spigot, Using one of the nylon ties, supplied, secure the ducting to the duct spigot.
IRI6WE3 and IRI9WE3 Installation and Operation Manual INSTALLATION – Ducted or Re-circulating The integrated rangehood can be installed in either ducted or re-circulating method. The integrated rangehood is supplied with a small length of flexible duct, although may not be sufficient in all installations. The installer needs to determine the method in which the rangehood will be installed and may need to supply the appropriate components to duct the rangehood correctly.
IRI6WE3 and IRI9WE3 Installation and Operation Manual INSTALLATION – Ducted or Re-circulating Re-circulation installation 150mm flexible duct is provided with the integrated rangehood for re-circulatiing installation. This type of installation can be executed to the top of a cupboard or through a bulkhead above the cupboard. In both cases a mesh cover will need to be supplied by the installer to keep out insects and vermin. The size of the duct pipe needs to be no less than 150mm in diameter.
IRI6WE3 and IRI9WE3 Installation and Operation Manual OPERATION The integrated rangehood is fitted with push button Back-lit electronic controls. There is 1 light push button and 3 speed push buttons, Low, Mid and High to control the air flow speeds. (Fig. 7) Fig. 7 Low Mid High Light Light Control To turn ON the halogen lights, depress the Light electronic push button once. When ON, the back lit push button will glow blue. To turn lights OFF, depress the Light electronic push button again.
IRI6WE3 and IRI9WE3 Installation and Operation Manual MAINTENANCE and CLEANING WARNING ALWAYS un-plug the rangehood PRIOR to any maintenance or cleaning being carried out, to avoid possible electric shock. To ensure long lasting performance and efficiency, regular maintenance and cleaning of your integrated rangehood should be performed. Replacing Halogen Bulbs After many hours of operation halogen bulbs may require replacement. This can be done by the owner.
IRI6WE3 and IRI9WE3 Installation and Operation Manual MAINTENANCE and CLEANING WARNING ALWAYS un-plug the rangehood PRIOR to any maintenance or cleaning being carried out, to avoid possible electric shock. Cleaning of Grease Filter We recommend cleaning of the grease filter to be done at least every 4 weeks. Cleaning of the grease filter ensures continued performance of the rangehood. Remove the grease filter and soak in warm to hot water containing liquid detergent.
