User Manual 600mm Gas Cooktop GFC60
Dear Customer, Congratulations on purchasing your new product from Home Appliances. To register your Parts and Labour Warranty, some conditions apply, please refer to your warranty card for more details and contact our Customer Care team on: 1800 444 357 Our Customer Care Centre is there to ensure you get the most out of your appliance. Should you want to learn more about your product and how to use it to its best potential or tips on cleaning, please feel free to call us on the above number.
This manual explains the proper installation and use of your appliance, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. In case of failure, only the Authorized Technical Service may repair this hob. Otherwise the guarantee will be null and void. Built-in Stainless Steel Gas Cooktop Warning General Safety ! ! Children’s Safety by licensed gasfitters / authorized persons.
Safety Instructions ! that its temperature does not exceed 75 degrees ! ! ! ! DO NOT SPRAY AEROSOLS IN THE VICINITY After connecting to gas, check for leaks using soapy solution, never a naked flame. DRAWER OR NEAR THIS APPLIANCE. ! ! Where a flexible hose assembly is used, ensure OF THIS APPLIANCE WHILE IT IS IN it is approved to AS/NZS 1869, Class B 10mm OPERATION. diameter and no more than 1.0metre in length.
Accessory Picture Name ( for reference only, physical unit maybe different) User Manual 1 Sealing tape 1 roll Additional labels Installation Quantity Before Installation: ! You have additional rating label in accessory bag, suggest 1 set attach it onto a surface where it can be read e.g. inside Overhead cupboards and range hood = 650 mm. Side and rear clearance = 200 mm to any burner edge.
2. Place Burner Box After having installed the hotplate, the GPO must always be in an accessible position. Apply the adhesive sealing tape to the underside lip of the burner box. Shown at G opposite. Place burner box into cutout hole and fit clamping brackets to clamp the hotplate to the bench. Wiring diagram 4. Gas Connection Install in accordance with relevant gas standards and/or codes of practice applicable.
ADJUSTING THE BURNER MINIMUM FLAME HEIGHT: NOTE: This adjustment can only be performed by the installer or an authorised service personnel. The minimum burner flame is factory adjusted for the gas type stated on the gas type label adjacent to the gas Description connection and should not require adjustment. Adjustment may be required if the hotplate has been converted Explanation These show which zone is under control. from Natural gas to Universal LPG or vice versa.
Maintenance & Troubleshooting TROUBLESHOOTING Cleaning and maintenance should be carried out with Servicing of the hotplates must only be done by an authorised service representative (see back of this booklet) and the the appliance cold especially when cleaning the hotplate must not be modified. Power must be disconnected before any servicing or maintenance is conducted. enameled parts. Avoid leaving alkaline or acid DO NOT MODIFY THIS APPLIANCE. substances(lemon juice, vinegar etc.
Distributed by: Home Appliances Pty. Ltd. 20 Carlotta Street, Artarmon NSW 2064 Tel: 02 9958 3111 Fax: 02 9958 3555 Email: info@hapl.com.au Website: www.hapl.com.
