Instruction Manual

Flex 12HRX/8HRX Standard, AB and Tandem Instruction Manual (FCC/CE)
September 2016
Page 16 of 43
1. For best reception the location of the receiver should be visible to the
operator at all time.
2. The location selected should not be exposed to high levels of electric noise. Mounting
the receiver next to an unshielded variable frequency drive may cause radio interference.
Always locate the receiver as far away from variable frequency drive and electric motor
as possible.
3. Ensure the selected location has adequate space to accommodate the receiver. If an
external antenna is used, to avoid the possibility of antenna damage always locate the
receiver where the antenna is free from any obstacles.
4. When installing an external antenna,make sure the receiver’s internal settings are
adjusted to EXT.
5. For better reception, make sure the receiver is in an upright position.
6. Drill four holes for mounting bracket type 1 and two holes for mounting bracket type 2
on the control panel, wall or location where the receiver is to be installed.
7. Make sure the screws, bolts or shock absorbers are tightened after installation (not
provided with the system).
Mounting Bracket Type 1 Mounting Bracket Type 2
8. Slide down the receiver along the guided track to secure the receiver to the mounting
bracket.
9. Remove the receiver by pressing down the bracket release and pull the receiver
upward until it clears the guided track.
ANTENAN：>EXT