Instruction Manual

Flex 12EPH/8EPH Standard, AB and Tandem Instruction Manual (FCC/CE)
September 2016
Page 8 of 43
2.4. SAFETY INFORMATION AND
RECOMMENDED TRAINING FOR RADIO
CONTROLLED EQUIPMENT OPERATORS
Anyone being trained to operate radio controlled equipment should possess as a minimum the following
knowledge and skills before using the radio controlled equipment.
The operator should:
• have knowledge of hazards pertaining to equipment operation
• have knowledge of safety rules for radio controlled equipment
• have the ability to judge distance of moving objects
• know how to properly test prior to operation
• be trained in the safe operation of the radio transmitter as it pertains to the crane, hoist, lifting device or
other material handling equipment being operated
• have knowledge of the use of equipment warning lights and alarms
• have knowledge of the proper storage space for a radio control transmitter when not in use
• be trained in transferring a radio control transmitter to another person
• be trained how and when to report unsafe or unusual operating conditions
• test the transmitter emergency stop and all warning devices prior to operation; testing should be done on
each shift, without a load
• be thoroughly trained and knowledgeable in proper and safe operation of the crane, hoist, lifting device, or
other material handling equipment that utilizes the radio control
• know how to keep the operator and other people clear of lifted loads and to avoid “pinch” points
• continuously watch and monitor status of lifted loads
• know and follow cable and hook inspection procedures
• know and follow the local lockout and tagout procedures when servicing radio controlled equipment
• know and follow all applicable operating and maintenance manuals, safety procedures, regulatory
requirements, and industry standards and codes
The operator shall not:
• lift or move more than the rated load
• operate the material handling equipment if the direction of travel or function engaged does not agree
with what is indicated on the controller
• use the crane, hoist or lifting device to lift, support or transport people
• lift or carry any loads over people
• operate the crane, hoist or lifting device unless all persons, including the operator, are and remain clear
of the supported load and any potential pinch points
• operate a crane, hoist or lifting device when the device is not centered over the load
• operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the sprockets,
drum or sheave
• operate any damaged or malfunctioning crane, hoist, lifting device or other material handling equipment