Instruction Manual

Flex 12EPH/8EPH Standard, AB and Tandem Instruction Manual (FCC/CE)
September 2016
Page 20 of 43
e. After 1 minute or 5 minutes of inactivity (pushbutton not pressed) the receiver MAIN
output are temporarily disconnected (refer to section 4.1.5 Inactivity Timer Settings).
Press any pushbutton or execute the START command to resume operation (refer to
section 4.1.4 Start Function Settings). The receiver MAIN output are also temporarily
disconnected when the system encounters strong radio interference, dead spots, low
battery condition, and system out of operating range.
f. Turn off the transmitter power by rotating the power switch key counter clockwise to
Off ( 0 ) position; it will disconnect the transmitter power and the receiver MAIN output
altogether. Turn it further counter clockwise to release the key.
5.2. A/B Rotary Select Operation (AB models)
Standard - Rotate to A position activates output output A, rotate to
B position activates output output B, rotate to A+B position
activates both output output.
5.3. Pitch & Catch Operation
Press the “PITCH” pushbutton for up to 2 seconds to release
control of the receiver. After 2-second grace period, rotate the
power switch key to START position for up to 2 seconds to gain
control of the receiver. The 2
nd
operator is unable to take control
of the receiver unless the 1
st
operator presses the “PITCH”
pushbutton. Refer to section 4.2.2.10 and section 4.2.3.2 on
how to set to this function.
5.4. Transmitter Access Card (TAC) Operation
After turning on the transmitter power, place the TAC directly over the RFID marking
located on the backside of the transmitter. A 2-second green on the Status LED
represents access card accepted. Status LED with
red blinks represents invalid access card. Then rotate
the power switch key to the START position for up to
2 seconds to begin operation. TAC is not required
after every transmitter inactivity restart, only during
initial transmitter power on.