Instruction Manual

Flex 12EPH/8EPH Standard, AB and Tandem Instruction Manual (FCC/CE)
September 2016
Page 15 of 43
4.1.3. Remote Pairing
A. Transmitter-to-Transmitter Pairing:
1) Rotate the power switch key to OFF ( 0 ) position.
2) With the STOP button elevated, press and hold PB1 and
PB3 at the same time.
3) Rotate the power switch key to ON ( I ) position.
4) Let go PB1 and PB3 at the same time (entered Remote
Pairing mode). The Status LED displays firmware version
with red, green and orange blinks.
5) Output data (original transmitter) by press and hold PB2 (Status LED off).
6) Receive data (new transmitter) by press and hold PB1 (Status LED blinks green).
7) When the Status LED (receiving data end) turns to constant green while both
pushbuttons are still pressed down the pairing is completed.
8) Exit Remote Pairing mode by rotate the power switch key to OFF ( 0 ) position.
→
Output data – original transmitter Receive data – new transmitter
(press and hold PB2) (press and hold PB1)
Note: During remote pairing make sure the distance between the two transmitters is within 1 meter.