User Manual

16/EN
6 Maintenance and care
General information
Service life of the product will extend and the
possibility of problems will decrease if the
product is cleaned at regular intervals.
DANGER:
Disconnect the product from mains supply
before starting maintenance and cleaning
works.
There is the risk of electric shock!
DANGER:
Allow the product to cool down before you
clean it.
Hot surfaces may cause burns!
• Clean the product thoroughly after each use.
In this way it will be possible to remove
cooking residues more easily, thus avoiding
these from burning the next time the
appliance is used.
• No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to
clean the product and wipe it with a dry
cloth.
• Always ensure any excess liquid is
thoroughly wiped off after cleaning and any
spillage is immediately wiped dry.
• Do not use cleaning agents that contain
acid or chloride to clean the stainless or
inox surfaces and the handle. Use a soft
cloth with a liquid detergent (not abrasive) to
wipe those parts clean, paying attention to
sweep in one direction.
The surface might get damaged by some
detergents or cleaning materials.
Do not use aggressive detergents, cleaning
powders/creams or any sharp objects
during cleaning.
Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass
since they can scratch the surface, which
may result in shattering of the glass.
Do not use steam cleaner
s to clean the
appliance as this may cause an electric
shock.
Cleaning the hob
Electric hobs
1. Turn off the hotplates and wait until they cool
down.
2. If necessary, clean the plates with a
cleaning agent (you can obtain
cleaners/softeners from specialty stores).
3. Warm only for a few minutes after cleaning
in order to have their top section dried.
4. Apply a thin layer of machine oil onto the top
surface of the hob regularly in order to
protect it.
Cleaning the control panel
Clean the control panel and knobs with a damp
cloth and wipe them dry.
Do not remove the control buttons/knobs to
clean the control panel.
Control panel may get damaged!