User Manual 600mm Electric Cooktop ESH60
Please read this user manual first! Dear Customer, Thank you for purchasing this product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use. If you handover the product to someone else, give the user manual as well.
TABLE OF CONTENTS 1 Important instructions and warnings for safety and environment 4 General safety.... Error! Bookmark not defined. Electrical safety .. Error! Bookmark not defined. Product safety .... Error! Bookmark not defined. Intended use ...... Error! Bookmark not defined. Safety for childrenError! Error! Bookmark not defined. Disposing of the old product ...........................4 Package information.......................................7 Future Transportation ...................................
1 Important instructions and warnings for safety and environment This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty.
or a similarly qualified person in order to avoid a hazard. • Only use the connection cable specified in the “Technical specifications”. • The appliance must be installed so that it can be completely disconnected from the mains supply. The separation must be provided by a switch built into the fixed electrical installation, according to construction regulations.
• Metallic objects such as knives, forks, spoons and lids should not be placed on the hotplate since they can get hot. • The appliance is not intended to be operated by means of an external timer or separate remote-control system. • Vapour pressure that build up due to the moisture on the hob surface or at the bottom of the pot can cause the pot to move. Therefore, make sure that the oven surface and bottom of the pots are always dry.
This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE). This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling. Do not dispose of the waste product with normal domestic and other wastes at the end of its service life. Take it to the collection center for the recycling of electrical and electronic equipment.
2 General information Overview 1 2 3 Hotplate Base cover Assembly clamp 4 5 6 Warning lamp Hotplates knob Burner plate 1 2 3 Warning lamp Hotplate Front right Hotplate Front left 4 5 Hotplate Rear left Hotplate Rear right 8/EN
Technical specifications Voltage / frequency Total power consumption Fuse Cable type / section Cable length External dimensions (height / width / depth) Installation dimensions (width / depth) Burners Front right Dimension Power Front left Dimension Power Rear left Dimension Power Rear right Dimension Power Technical specifications may be changed without prior notice to improve the quality of the product. Figures in this manual are schematic and may not exactly match your product.
3 Installation Product must be installed by a qualified person in accordance with the regulations in force. The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorized persons which may also void the warranty. Preparation of location and electrical installation for the product is under customer’s responsibility. DANGER: The product must be installed in accordance with all local electrical regulations.
Installation and connection • Product can only be installed and connected in accordance with the statutory installation rules. Electrical connection Connect the product to a grounded outlet/line protected by a fuse of suitable capacity as stated in the "Technical specifications" table. Have the grounding installation made by a qualified electrician while using the product with or without a transformer.
3. Turning the hob again, align and place it on the counter. 4. You can secure your hob to the counter by using the clamp and the screws supplied. * # 1 2 3 4 5 6 min. 20 & max. 40 mm min. 50 mm Hob Screw Installation clamp Counter Putty Separator plate When installing the hob onto a cabinet, a shelf must be installed in order to separate the cabinet from the hob as illustrated in the above figure. This is not required when installing onto a built-in oven.
4 Preparation Tips for saving energy The following information will help you to use your appliance in an ecological way, and to save energy: • Defrost frozen dishes before cooking them. • Use pots/pans with cover for cooking. If there is no cover, energy consumption may increase 4 times. • Select the burner which is suitable for the bottom size of the pot to be used. Always select the correct pot size for your dishes. Larger pots require more energy.
5 How to use the hob the cooking zone you want instead of sliding it. General information about cooking Never fill the pan with oil more than one third of it. Do not leave the hob unattended when heating oil. Overheated oils bring risk of fire. Never attempt to extinguish a possible fire with water! When oil catches fire, cover it with a fire blanket or damp cloth. Turn off the hob if it is safe to do so and call the fire department.
Cooking level 1 2—3 4—6 warming stewing, simmering cooking, roasting, boiling Turning off the hotplates Turn the hotplate knob to OFF (upper) position.
6 Maintenance and care General information Service life of the product will extend and the possibility of problems will decrease if the product is cleaned at regular intervals. DANGER: Disconnect the product from mains supply before starting maintenance and cleaning works. There is the risk of electric shock! DANGER: Allow the product to cool down before you clean it. Hot surfaces may cause burns! • • • • Clean the product thoroughly after each use.
7 Troubleshooting Product emits metal noises while heating and cooling. • When the metal parts are heated, they may expand and cause noise. >>> This is not a fault. Product does not operate. • • The mains fuse is defective or has tripped. >>> Check fuses in the fuse box. If necessary, replace or reset them. Product is not plugged into the (grounded) socket. >>> Check the plug connection.
Distributed by: Home Appliances Pty. Ltd. 20 Carlotta Street, Artarmon NSW 2064 Tel: 02 9958 3111 Fax: 02 9958 3555 Email: info@hapl.com.au Website: www.hapl.com.
