User Manual

gas conversion
■ Take precautions on the operations and adjustments to be carried out when
converting from one gas to another.
■ All work must be carried out by a qualified technician.
■
Before you begin, turn off the gas and electricity supply to the appliance.
&KDQJHWKHLQMHFWRURIWKHEXUQHUV
1
5HPRYHWKHSDQVXSSRUW%XUQHUOLGDQG)ODPHVSUHDGHU
8QVFUHZWKHLQMHFWRUXVLQJDPPER[VSDQQHUDQGUHSODFHLWZLWK
WKHVWLSXODWHGLQMHFWRUIRUQHZJDVVXSSO\
&DUHIXOO\UHDVVHPEOHWKHDOOFRPSRQHQWV
$IWHULQMHFWRUVDUHUHSODFHGLWLVDGYLVDEOHWRVWURQJO\WLJKWHQWKH
injector in place.
2




Injector
Control handle
Tap
Sealing ring
■
Do not dismantle the tap shaft :
■
Before placing the burners
not blocked.
■
A
full operational test and a test
(such as soap water or gas
a qualified technician or installer
has to mark “V”
on the right gas
category
to match with the
in rating plate.
Remove the previous
setting “V” mark.
in the event of a malfunction,
change the whole tap.
back on the top place, make sure
that the injector is
for possible leakages must be
carried out after
gas conversion.
■
After completing conversion,
setting
detector)
Tuurn the taps down to minimum
RRemove the knob from the tap and place a small
‐
‐
‐
turning
does then remove the control knob and make further
from maximum flow to minimum flow. If it
Adjustme
n
n
t of minimum l
e
e
vel of the flam
e
e
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
/
must be tightly screwed in.
For butane propane gas, the adjusting screw
Refit the control knob.
ake sure that the flame does not go out by quickly
M
adjustments to the gas flow, testing it again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
24