User Manual

installing the appliance
Bottom view
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
ezis eht hctam taht seloh eht revo )B(tekcarb eht ecalP .1
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position
.
ti rewol yltneg neht dna revo kcab boh eht nrut ylluferaC .2
into the aperture hole that you have cut out.
a otni stekcarb eht tsujda ,boh eht fo htaenrednu eht nO .3
position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
position.
(A) SEALING STRIP
(C) SCREW (B) BRACKET
dna dil renrub eht ,stroppus nap eht evomeR .1
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2.
Apply the sponge provided around the
edge of the appliance.
ro tnega gnilaes eht ni pag a evael ton oD .3
overlap the thickness.
Sealing strip (A)
(H) HOB (Cooktop)
19