User Manual

cleaning and maintenance
yawa dna sdrawpu meht gnillup yb sredaerpS emalF dna sdil renrub eht evomeR
from the top plate.
dna retaw toh ni meht kaoS a little
.
eht taht erus ekaM .ylluferac meht yrd dna epiw ,meht gnihsaw dna gninaelc retfA
flame holes are clean and completely dry.
.sdrawretfa yrd dna htolc pmad a htiw puc renrub eht fo strap dexfi eht epiW
tuo-gnurw llew a htiw ecived noisivrepus emafl dna ecived noiting eht epiw yltneG
cloth and wipe dry with a clean cloth.
ton si rotcejni eht taht erus ekam
,etalp pot eht no kcab srenrub eht gnicalp erofeB
blocked.
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
.sehcton eht otni yltcaxe tfi tsum snip gnitacol ehT -
i
Burner Lid
washing up liquiddetergent or
15
Re-assemble of the Rapid, Semi-rapid and
Auxilliary burners as follows:
Flame Spreader
Burner Cup
Injector
Ignitor
Flame Failure Device
1. Place the flame spreader on the burner cup so that the Ignitor and flame failure
device extend through their respective holes in the flame spreader.
NOTE: The flame spreader must seated into position correctly.
2. Position the burner lid onto the flame spreader so that the retaining pins fit into
their respective recesses.