User Manual

how to use the appliance
To ignite a burner:
o Press in the control knob of the burner that you wish to light and turn it
anti-clockwise to the maximum position.
o If you keep the control knob depressed, the automatic ignition for the
burner will operate.
o You should hold down the control knob for 15 seconds after the flame on
the burner has lit. If after 15 seconds the burner has not lit, stop operating
the device and open the compartment door and/or wait at least 1 min before
attempting a further ignition of the burner.
o After this 15-second interval, to regulate the flame you should continue
turning the control knob anti-clockwise until the flame is at a suitable level.
The operating position MUST be
at
a position between the maximum and
minimum position.
o To switch the burner o, turn the control knob fully clockwise to the gas o
position.
o In case of power failure, the burners can be lit by carefully using a match.
12