User's Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Using the Device
- 3.1 Power On/Off and Sleep Options
- 3.2 Home Screen
- 3.3 Configuring Your SIM Card
- 3.4 Enabling Wi-Fi and Connecting to a WLAN
- 3.5 Enabling Bluetooth and Pairing with Bluetooth Device
- 3.6 Connecting to a Network via LAN Port
- 3.7 Using the GPS Feature
- 3.8 Enabling and Using the NFC Features
- 3.9 Using the Camera Feature
- 3.10 Ignition Management
- Chapter 4 Troubleshooting
- 18 -
Getting Started
For Non-Vehicle Application
For non-vehicle usage, please use the provided 3-pin terminal block with the
screws to wire the power cable rst.
1. Wire your power cable and insert the cable to the terminal block as shown
below:
-
+ +
Use a screwdriver to
clamp down the wires.
2. Plug the terminal block into the power connector and then tighten the
screws to secure the terminal block in place.