User's Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Using the Device
- 3.1 Power On/Off and Sleep Options
- 3.2 Home Screen
- 3.3 Configuring Your SIM Card
- 3.4 Enabling Wi-Fi and Connecting to a WLAN
- 3.5 Enabling Bluetooth and Pairing with Bluetooth Device
- 3.6 Connecting to a Network via LAN Port
- 3.7 Using the GPS Feature
- 3.8 Enabling and Using the NFC Features
- 3.9 Using the Camera Feature
- 3.10 Ignition Management
- Chapter 4 Troubleshooting
- 17 -
Getting Started
2.4 Power Connection
2.4.1 Power Connector
The device requires a 9~36V DC power supply. A 3-pin terminal block
receptacle is located on the side of the device for DC power connection.
1 G
+
S
2
3
(-)
(+)
(+)
2.4.2 Wiring Cables to 3-pin Terminal Block
For Vehicle Application
For vehicle usage, please use the provided 3-pin terminal block with the screws
to wire the power cable rst.
1. Wire your power cable and insert the cable to the terminal block as shown
below:
-
+
ACC
Use a screwdriver to
clamp down the wires.
2. Plug the terminal block into the power connector and then tighten the
screws to secure the terminal block in place.