User`s manual

- 33 -
Driver & AP
3.5.3 Removing the Box PC from the DIN Rail
1. Make sure power is off, and disconnect all cables from the computer.
2. Hold the Box PC with both hands and push downwards. As the clip releases,
lift the bottom of Box PC slightly.
3.6 Grounding the Box PC
Follow the instructions below to ground the box PC onto land. Be sure of
following any grounding requirements in your place.
1. As the gure illustrates above, remove the ground screw located on the
bottom-left of the rear panel.
2. Attach the ground wire to the rear panel with the screw.
Warning Whenever installing the unit, the ground connection must
always be made rst of all and disconnected lastly.