User`s manual

- 29 -
Installation and Maintenance
4.1.2 Install Memory Module
The main board has one dual inline memory module (DIMM) socket. Load the
computer with a memory module of higher capacity to make programs run
faster. The memory module for the computer’s SO-DIMM socket should be
a 204-pin DDR3 with a “key notch” off the centre among the pins. There are
another two notches at left and right sides of the memory module to help x
the module in the socket.
To install the DDR3 memory module:
1. Find the SO-DIMM socket on the board. The SO-DIMM socket is horizontal
type, and it has two spring-loaded locks to x the memory module.
2. Confront the memory module’s edge with the SO-DIMM connector. Align the
memory module’s key notch with the break on the SO-DIMM socket. Fully
plug the memory module obliquely until it cannot be plugged any more.
3. Press down the memory module until it gets auto-locked in place.
break
side notch
key notch
side notch
To uninstall the DDR3 memory module:
Press spring-loaded locks at corners to right and left ways. Remove the mem-
ory module.