Install Drawing

2 Installing the Compressor

2.3 Drilling & Mounting the Compressor

 Establish the mounting hole locations for the compressor by using the compressor

backing plate as a template, or referring to Fig.3. for exact sizes.

Figure 3.

NOTE : The mounting bracket holes are slotted in a circular pattern allowing the

backing plate and bolts to be partially rotated relative to the compressor.

This should make finding a place for the four bolt holes an easier task.

Figure 4.

 Drill the four mounting holes at a diameter of 6.5mm [1/4 inch].

NOTE : Try to drill mounting holes accurately. Use the backing plate as a drilling

template if desired. Holes should never be drilled open to more than 8mm

[0.31”] in size to compensate for misalignment.