Installation Guide

ManualsBrandsARAS SECURITY ManualsMotion SensorARAS Security Wireless Motion Sensor

Wireless Motion Sensor

Installation Guide

What is in the box What you will need

X A laptop or smartphone running the DT Studio

web application studio.d21s.com>

X If your company does not have a DT Studio

organization, get started at d21s.com/start>

X One or more Cloud Connectors (gateway) to

forward sensor data to the DT Cloud>

X A #1 Phillips screwdriver or power drill with a #1

Phillips driver bit

Wireless Motion Sensor

2 AA batteries

Mounting plate

3 screws

3 wall anchors1 safety screw

Rev 1.0

Summary of content (4 pages)

PAGE 1
Rev 1.0 Installation Guide Wireless Motion Sensor What is in the box What you will need X A laptop or smartphone running the DT Studio   web application studio.d21s.com> X If your company does not have a DT Studio organization, get started at d21s.com/start> Wireless Motion Sensor Mounting plate X One or more Cloud Connectors (gateway) to forward sensor data to the DT Cloud> X A #1 Phillips screwdriver or power drill with a #1 Phillips driver bit.
PAGE 2
Planning the installation Cloud Connector Small site Number of Motion Sensors  The number of motion sensors needed depends on the size of the area that needs to be monitored. Each sensor can cover up to 150 sqm (1600 sqft) if installed at the maximum height of 3.6 meters (12 ft). See step 5 for more details about installation height and detection area.
PAGE 3
On the installation day 1 Install the Cloud Connectors in the locations found during planning. Visit support.d21s.com to see best practices for Cloud Connector installations. 3 Claim the sensor in Studio by scanning the QR code found on the device. The same code is printed on the packaging label. Sensor name 2 Remove the bracket by rotating it counter clockwise and remove the battery tabs to activate the sensor.
PAGE 4
There are two options for mounting the sensor. 6 Option 1   Attach the mounting plate to a clean ceiling surface using the adhesive backing. Add a single screw to the center for extra safey. Please note: the adhesive creates a strong bond to the surface and can’t be removed and reapplied once placed. 7 Lock the sensor in place by turning it clockwise. 8 Fasten the included safety screw to lock the sensor in place.