ADAPTER PLATE Mounting guide
Box contents RJ45 Cap Adapter plate Cable grommet M4 x 10 mmL M4x 8 mmL Required: • T20 screwdriver AVA-ADA-PLA-MG-01 • Drill and drill bit • Suitable fasteners for the wall or junction box Copyright © 2022, Ava Video Security. All rights reserved.
Installing the adapter plate 1 Determine which hole pattern to use by measuring the threaded holes on your junction box. 2 Locate the corresponding pattern on the adapter plate and drill the holes. 3 To avoid junction box water ingress we recommend to apply sealant between the Adapter plate and the wall. Make sure the junction box can carry the weight of the installed camera. Wall mount is also supported, refer to the Datasheet for more information.
5 7 8 AVA-ADA-PLA-MG-01 Remove pull-off tab Copyright © 2022, Ava Video Security. All rights reserved.
9 Attach the adapter plate to the junction box or wall using suitable screws AVA-ADA-PLA-MG-01 10 Attach the Bullet wall bracket to the adapter plate using the supplied screws and washers. Copyright © 2022, Ava Video Security. All rights reserved. 11 Refer to the Bullet camera Mounting guide for the final installation steps.
