User Instructions

Arapaho Technologies Inc. LiquidAider™ Draft May 2019 Instructions
This is the full assembly in simple terms:
1. Mount the button and button shield on your handlebar next to your grip.
2. Replace the suck tube from your hydration bladder with our pump.
3. Connect the battery to the pump and turn it on.
4. Connect long tube to the pump, insert the large half of the magnetic
disconnect backflow preventer into the end of the tube.
5. Slide the bladder, pump, tube, and battery into your backpack.
6. Route the tube, antenna, and backflow preventer out the top of the backpack.
7. Install the nozzle in your helmet.
8. Secure the helmet tube to the helmet with our helmet clips.
9. Insert the small half of the magnetic disconnect backflow preventer into the
end of the helmet tube.
PUMP
The pump is waterproof and has a 90-degree connector that plugs into your
hydration bladder. It also has an outlet barbed connection at the top and it has a
connector for connecting the battery. The antenna is the gold wire with the silver
barrel at the top.