User Instructions
ArapahoTechnologiesInc. LiquidAider™ DraftMay2019Instructions
This is the full assembly in simple terms:
1. Mount the button and button shield on your handlebar next to your grip.
2. Replace the suck tube from your hydration bladder with our pump.
3. Connect the battery to the pump and turn it on.
4. Connect long tube to the pump, insert the large half of the magnetic
disconnect backflow preventer into the end of the tube.
5. Slide the bladder, pump, tube, and battery into your backpack.
6. Route the tube, antenna, and backflow preventer out the top of the backpack.
7. Install the nozzle in your helmet.
8. Secure the helmet tube to the helmet with our helmet clips.
9. Insert the small half of the magnetic disconnect backflow preventer into the
end of the helmet tube.
BUTTON
:
The button is self-contained and waterproof. It mounts on your bike next to
(typically) the left-hand grip. You will need to move your kill switch inboard a bit.
Before mounting the button, gently pull the battery connection tab out of the button.
This activates your battery and never needs to be done again.
Here is the button and the guard. It is highly recommended that you use the button
guard to protect the button from damage during riding and from crash impact.